Acura Keyless Remote Steps To Program My Keyless Remote For Acura RSX 2002?
Steps to program my keyless remote for Acura RSX 2002? - acura keyless remote
Open the glove box. The interior is a book called "Owner's Manual." Index search the vehicle by remote control and turn the page. To find a program guide.
|
2 comments:
I can not confirm as I have not yet done. This is a copy-paste from a forum.
You'll find instructions for programming a keyless transmitter.
Transmitter Code Retention:
The codes of up to three channels can be played in memory of the receiver without a key role. (If you save a session code, the code was entered, be deleted.)
NOTE: It is important to keep the time between each step. Make sure that the doors are closed and the trap.
1. Turn on the ignition (ii).
2. Within 1 to 4 seconds. Slide lock or unlock button on the transmitter to the transmitter to the receiver of the audio unit.
3. Within 1 to 4 sec., Turn the power switch.
4. 1 to 4 sec., The Turn ignition (ii).
5. Within 1 to 4 seconds. Slide lock or unlock button on the transmitter to the transmitter to the receiver of the audio unit.
6. Within 1 to 4 sec., Turn the power switch.
7. Within 1 to 4 sec., Turn on the ignition of SwitzerlandCH ON (II).
8. Within 1 to 4 seconds. Slide lock or unlock button on the transmitter to the transmitter to the receiver of the audio unit.
9. Within 1 to 4 sec., Turn the power switch.
10. 1 to 4 sec., The Turn ignition (ii).
11. Within 1 to 4 seconds. Slide lock or unlock button on the transmitter to the transmitter to the receiver of the audio unit.
12. Now, you must have heard the sound of the door lock controls! Within 1 to 4 seconds. Slide block the sender or re-unlock button.
13. Within 10 seconds., "The goal every other channel (up to two more), the codes, press the save in the receiver and the transmitter to lock or unlock the keys. Check to see if you can hear the sound of rams lock is stored after each transmitter.
14. Turn the power switch and leave.
15. Ensuring the smooth operation of the transmitter.
The instructions seem a little repetitive, but its program properly unlocked tTRANSMITTER.
Good luck .=)
sitting in the car with the keys in the ignition and the remote in hand. Turn the ignition key to the ON position. press the lock button on the remote control and stop the firing. Repeat these steps several times until you hear the door to try to block when you press the button. When you hear the sound, press the release button, and close off the power switch. the key from the ignition and test the remote alone. it should work. To summarize:
in
News keylock
On / Off
in
Keylock
On / Off
in
Keylock
On / Off
in
Keylock
* Noise
Unlocking
Ignition off.
Post a Comment